Bijur Cross-Reference
Bijur Delimon is one of the best-known names in centralised lubrication, built around a few named system types: Single-Line Resistance (SLR), Positive Displacement Injector (PDI), and progressive divider-valve manifolds (the M2500G, 3000 and PVBM series). AMAG's own range covers the same duty classes. This isn't a part-number match. Send the nameplate code and a photo and we'll confirm the exact one.
Which AMAG family matches your system
Bijur
Single-Line Resistance (SLR)
A low-pressure oil system for light or medium machinery, up to 100 points: oil metered to each point through calibrated resistance rather than a mechanical valve.
AMAG's resist-type distributors run the same restriction-based, single-line proportioning duty, driven by a TZ, HL or NKHY-8 pump built without a pressure take-off mechanism, the same pairing AMAG's own datasheets specify for these distributors.
Bijur
PDI (Positive Displacement Injector)
A metered single-line system: each injector discharges a fixed, measured dose of oil per pump cycle.
AMAG's volumetric distributors (34 Type, 35 Type, RH3 Type) work on the same fixed-dose, positive-displacement principle, driven by a TZ or HL pump fitted with the pressure take-off mechanism the dosing cycle needs. The 35 Type and RH3 Type also run grease builds (RH3's G/GH) on the same principle. Click through for the pump each pairs with on that build. The 35 Type's M12×1 port also needs a PD35612 / PD35812 adapter from AMAG's fittings range to take standard tube.
Bijur
Progressive divider-valve manifolds (M2500G, 3000, PVBM series)
Sequential piston blocks (each block's piston completes a full discharge before the next one fires) feeding up to 20 points from 3 to 10 valve blocks per manifold.
AMAG's SD-series and U-Shaped Integrated Progressive distributors use the identical sequential-block principle, both running on a ZJ or PJ grease pump. Each also pairs with a further pump of its own; click through for the full list.
What AMAG carries
Motor-driven gear pumps with level switch, timer options and pressure take-off.
35 kgf/cm² output for platens, tie bars and progressive block systems.
Volumetric, inspecting, progressive block and resist-type proportioning.
The plumbing between the pump and the point: fittings, hose and adaptors.
Frequently asked questions
Is an AMAG pump a direct replacement for my Bijur part?
Sometimes, but not automatically: output pressure, discharge rate and port thread all have to match before it's a safe swap. Send the nameplate code and a photo and we'll confirm rather than guess.
What should I send to get an answer?
The full code stamped on the nameplate, plus a clear photo of the plate itself. Lubrication pump and distributor order codes carry suffixes (outlet count, pressure class, voltage) that change the spec, and a partial code is a guess either way.
Does AMAG carry a replacement for Farval's Dualine system?
No. AMAG's range covers single-line resistance, positive-displacement and progressive-block duty, not the two-line reversing architecture Farval's Dualine systems use. If that's what's on your machine, tell us on WhatsApp and we'll say so rather than offer a mismatch.
Identify your Bijur part
Send the nameplate code and a photo. We'll confirm whether an AMAG equivalent exists and quote it.